Prusa I3 MK3
View
Options
Preview new Authoring Experience
History
1
2
3
4
5
6
7
8
9
Introduction
Details
Guide Steps
Review
Quiz
Its usually helpful to raise the Extruder off the bed by 20-30mm before changing filament.
If the extruder is already raised off the bed, skip to the net step.
Press and hold the encoder knob until the display changes to Z-height adjustment (about 1 second)
Rotate the control knob CLOCKWISE to raise the Z-height (20-50 mm should be fine).
Press the control knob again to exit to the main menu.
« Introduction
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.