SawStop 10" Table Saw
View
Options
Preview new Authoring Experience
History
1
2
Introduction
Details
Guide Steps
Review
Quiz
Only adjust the blade angle when the saw is stopped.
Loosen the angle adjustment locking knob located in the center of the angle adjustment wheel by turning the knob counter-clockwise.
To adjust the tilt angle of the blade, loosen the tilt lock knob and turn the tilt handwheel until the blade is at the desired angle.
The tilt (bevel) angle of the blade can be adjusted between 0° and 45°.
Turn the tilt hand wheel counter-clockwise to increase the tilt angle, and clockwise to decrease the tilt angle.
Lock the tilt angle by turning the tilt lock knob clockwise until tight.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.