Difficulty
Moderate
Steps
2
Time Required
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
User-Contributed Guide
This guide is not managed by the site's staff.
Introduction
The Lansing Makers Network supplies a standard general purpose 10" blade for the SawStop table saw.
-
-
Only adjust the blade height when the saw is stopped.
-
Loosen the height adjustment locking knob located in the center of the height adjustment wheel by turning the knob counter-clockwise.
-
Turn the handwheel clockwise to raise the blade, and counter-clockwise to lower the blade.
-
Use a tape measure as illustrated to set the height of the blade as appropriate for the operation being performed. You can also use existing stock, gauge blocks or Mag-Shims to determine the appropriate height.
-
For through-cuts the blade should be between 1/8” and 1/4” above the surface of the stock. This ensures the blade will cut all the way though while not exposing any more to contact than needed.
-
Lock the height adjustment wheel by turning the locking knob clockwise.
-
-
-
Only adjust the blade angle when the saw is stopped.
-
Loosen the angle adjustment locking knob located in the center of the angle adjustment wheel by turning the knob counter-clockwise.
-
To adjust the tilt angle of the blade, loosen the tilt lock knob and turn the tilt handwheel until the blade is at the desired angle.
-
The tilt (bevel) angle of the blade can be adjusted between 0° and 45°.
-
Turn the tilt hand wheel counter-clockwise to increase the tilt angle, and clockwise to decrease the tilt angle.
-
Lock the tilt angle by turning the tilt lock knob clockwise until tight.
-
Cancel: I did not complete this guide.
One other person completed this guide.
