-
-
The Frame Slop error means that the operation you were about to perform (running a job or using the Frame function) would have caused the machine to drive beyond its maximum limits in X or Y.
-
-
Check that you have set the origin on the machine after loading your job.
-
-
-
The machine protected error usually means that the door switch was not completely engaged.
-
Try pressing down on the lid. You should be able to hear a faint "click" when the switch closes.
-
If the switch doesn't stay closed, create an issue on talk.
-
-
-
This error message means that the laser cutter does not detect water flow through the machine.
-
Check that the water pump is on.
-
Access the diagnostics panel to confirm that the protection light is not on.
-
If the light is on, and the pump is running, create an issue on talk.
-
