NewCNC Router
View
Options
Preview new Authoring Experience
History
1
2
3
4
5
6
7
Introduction
Details
Guide Steps
Review
Quiz
Arrange the top spoil board panels if necessary.
Find screws of the proper length. They should be shorter than the thickness of your stock + 1in.
Screws that are too long can damage the vacuum spoil board.
Drill holes larger then the screw threads through your stock, but not into the spoil board.
Install screws as needed to hold your material.
Cutting into a screw will ruin the router bit. Use caution and ensure that the screws are well away from the cutting toolpaths.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.