Loosen the angle lock knob by turning the handle down (toward the ground).

Grasp the table handle and rotate the handle toward you to ensure that the fence is resting against the 90 degree angle stop.

If the fence slides past 90 degrees, the angle stop block has been flipped up. Locate the angle stop block on the top of the fence support and flip it back down to adjust the fence to 90 degrees.

If using the jointer to create a chamfer or bevel, set the angle to your desired bevel instead of 90 degrees. It is highly preferred to tip the fence toward you instead of away from you as it provides much more stability to the material.

If using the jointer to create a chamfer or bevel, set the angle to your desired bevel instead of 90 degrees. It is highly preferred to tip the fence toward you instead of away from you as it provides much more stability to the material.