-
-
Jog the gantry to the rear of the machine to allow room to clear and affix your material.
-
Use the arrow keys on the keyboard to move the gantry forward/back and left/right.
-
Use the Page Up / Page Down keys to jog the head up and down.
-
Press the "TAB" key on the keyboard to open the jog flyout to adjust jog speed or jog using the mouse/touchscreen.
-
If you park the head at the rear of the machine when done using it, other users won't have to power the machine to affix their material.
-
-
-
Check for raised spot or debris on the bed. Use a scraper to remove them.
-
Screws being driven into the spoilboard tend to raise a "burr" around the hole when removed.
-
These raised areas can cause your part to not sit fully on the bed.
-
-
-
Secure your material to the bed of the machine using clamps or screws.
-
Cancel: I did not complete this guide.
One other person completed this guide.
